Renault Clio: Front left-hand wiring: Connector access
I - LOCATION OF CONNECTORS

- Connection R 107 (front left-hand wiring/dashboard
wiring connection) composed of two to four connectors
depending on equipment.

- R 374 connector (front left-hand wiring/rear left-hand
wiring connection).

- Connection R 67 (front left-hand wiring/engine wiring
harness connection) composed of two to three
connectors depending on equipment.

- R 33 connector (front left-hand wiring/front bumper
wiring connection).
II - ACCESS TO CONNECTORS
IMPORTANT
Consult the safety and cleanliness advice and
operation recommendations before carrying out
any repair (see 88A, Wiring harness, Wiring:
Precautions for the repair, 88A-5).
WARNING
To prevent damaging the connectors, consult the
disconnection procedure (see Connector: Disconnection
and reconnection) (Technical Note
6015A, 88A, Wiring).
- Switch off the ignition.
- Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting, 80A-1).
1 - Access to the R 107 connectors
LEFT-HAND DRIVE

- Remove the dashboard side face (1).

- Remove:
- the dashboard trim piece (2),
- the dashboard lower trim bolt (3).

- Remove:
- the dashboard lower trim bolt (4).
- the dashboard lower trim.

- Disconnect the connectors from connection R 107.
RIGHT-HAND DRIVE
- Remove the glovebox (see Glovebox: Removal -
Refitting) (MR 393, 57A, Interior equipment).

- Disconnect the connectors from connection R 107.
2 - Access to the R 374 connector
- Remove the front left-hand door sill lining (see Front
door sill lining: Removal - Refitting) (MR 393,
71A, Body internal trim).

- Disconnect the R 374 connector.
3 - Access to the R 67 connector

- Remove:
- the bolts (5) from the Protection and Switching Unit
cover,
- the Protection and Switching Unit cover.

- Disconnect the connectors from connection R 67.
4 - Access to the R 33 connector
- Remove the front section of the front left-hand wheel
arch liner (see Front wheel arch liner: Removal -
Refitting) (MR 393, 55A, Exterior protection).

- Disconnect the R 33 connector.
READ NEXT:
LEFT-HAND DRIVE
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
I - LOCATION OF CONNECTORS
R 67 connector (Engine wiring harness/front left-hand
wiring connection).
Depending on the engine, connection R 67 is composed
of three or four connectors.
K4J or K4
SEE MORE:
PANORAMIC SUNROOF
IMPORTANT
Before working on or near a safety system component;
make sure that the airbag computer is
locked using the Diagnostic tool. When this
function is activated, all the triggering lines are
inhibited and the airbag warning light on the
instrument panel is continuously lit (
Sill panel: Description
B85 or K85
To replace this part, also order the expanding inserts
corresponding to each of the following cases.
The options for replacing this part are as follows:
partial replacement of the front end section, order the
exterior A-pillar insert (see 40A, General informat
© 2016-2025 Copyright Renault Clio Owners Club
