Renault Clio: Front side door protective strip: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Mechanisms And Accessories / Exterior Protection / Front side door protective strip: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Unclip the blanking cover (1).
- Remove the bolt.
- Remove the side mounted indicator (2) using a small flat screwdriver.
- Disconnect the power supply connector.
II - REMOVAL OPERATION FOR PART CONCERNED
- Slide the door rubbing strip towards the rear of the vehicle.
III - REFITTING OPERATION FOR PART CONCERNED
- Slide the door moulding towards the front of the vehicle.
IV - FINAL OPERATION.
- Refit:
- the protective strip mounting bolt,
- the blanking cover,
- the mounted indicator.
Rear side door protective strip: Removal - Refitting
B85 or K85
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Strip off the adhesive (1).
- Remove the bolt.
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Slide the door moulding towards the front of the vehicle.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Slide the door moulding towards rear of the vehicle.
II - FINAL OPERATION.
- Refit:
- the protective strip mounting bolt,
- the adhesives (Part no: 77 01 465 890).
C85 or S85
REMOVAL
OPERATION FOR REMOVAL OF PART CONCERNED
- Unclip the rear wing protective strip (1).
REFITTING
I - REFITTING PREPARATION OPERATION
- Check the condition of the clips and replace them if necessary.
II - REFITTING OPERATION FOR PART CONCERNED
- Clip on the rear wing protective strip.
Roof protection strip: Removal - Refitting
C85 or S85
REMOVAL
Note: It is possible to replace the access flap for mounting the roof rack bars.
OPERATION FOR REMOVAL OF PART CONCERNED
- Carefully unclip the roof protection strip.
REFITTING
I - REMOVAL PREPARATION OPERATION
- Check the condition of the clips (1) and replace if necessary.
II - FINAL OPERATION.
- Clip the roof protection strip in position.
READ NEXT:
Front wheel arch liner: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove the front wheel (see Wheel: Removal - R
Rear bumper: Stripping - Rebuilding
B85 or C85 or S85, and EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2 or
EQUIPMENT LEVEL EA3 or
EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5, and DOCUMENTATION PHASE 1
STRIPPING
I - STRIPPING PREPARATION O
SEE MORE:
Interior trim maintenance
A well-maintained vehicle will last
longer. It is therefore recommended to
maintain the interior of the vehicle regularly.
A stain should always be dealt with
swiftly.
Whatever type of stain is on the trim,
use cold (or warm) soapy water with
natural soap.
Detergents (washing-up liquid
K4J or K4M
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
WARNING
To prevent damage to the wiring harness when
refitting, observe the original routing.
REMOVAL
I - REMOVAL PR
