Renault Clio: Ignition switch: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting, 80A-1).


- Remove:
- the plastic rivet (2),
- bolt (3).

- Remove the door seal.
- Unclip the dashboard side face (4).

- Remove:
- the bolt (5),
- the dashboard lower trim (6).

- Remove the lower cover (7).
- Disconnect the connectors.
- Remove:
- the driver's side front airbag (see 88C, Air bag and
Pretensioners, Driver's frontal airbag: Removal
- Refitting, 88C-22),
- the steering wheel (see Steering wheel: Removal
- Refitting) (MR 392, 36B, Power-assisted steering).

- Remove the bolts (8) under the lower half cowling.
- Unclip the lower and upper half cowling.

- Unclip the upper half cowling from the dashboard gaiter (9).
- Pull the lower half cowling out from the steering column
adjustment handle.
- Remove:
- the steering column switch assembly (see 84A,
Control - Signals, Steering column switch assembly:
Removal - Refitting, 84A-4),
- the antenna/transponder ring (see 82A, Engine
immobiliser, Transponder ring: Removal - Refitting, 82A-13).

- Unclip the wiring harness clip.
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Make a saw mark on the shear bolt.

- Remove the bolt (11).
- Disconnect the connector.

- Position the ignition key between the first and second position
(+Accessories and +APC) (12).
- Press on the retaining lug (13).
- Remove the ignition switch.
REFITTING
I - REFITTING PREPARATIONS OPERATION
Note:
To protect against tampering, always secure the
ignition switch with a shear bolt.
Be sure to recover the sheared-off part of the
bolt after it has been tightened.
II - REFITTING OPERATION FOR PART
CONCERNED

- Position the ignition key between the first and second position
(+Accessories and +APC) (12).
- Press on the retaining lug (13).
- Fit the ignition switch.

- Tighten the shear bolt (14) until the bolt head shears
off.
- Connect the starter switch connector.
- Lock the starter switch connector.
III - FINAL OPERATION.

- Clip on the wiring harness clip (15).
- Refit:
- the antenna/transponder ring (see 82A, Engine
immobiliser, Transponder ring: Removal - Refitting, 82A-13),
- the steering column switch assembly (see 84A,
Control - Signals, Steering column switch assembly:
Removal - Refitting, 84A-4),
- the lower half-shell.
- Clip on:
- the dashboard gaiter on the upper half cowling (9),
- the upper half cowling to the lower half cowling.
- Refit:
- the bolts (8) under the lower half cowling,
- the steering wheel (see Steering wheel: Removal
- Refitting) (MR 392, 36B, Power-assisted steering),
- the driver's front airbag (see 88C, Air bag and Pretensioners,
Driver's frontal airbag: Removal -
Refitting, 88C-22).
- Connect the connectors on the lower cover (7).
- Refit:
- the lower cover (7),
- the dashboard lower trim (6).
- Tighten:
- the dashboard lower trim bolt (5)
- the lower cover bolt (3),
- Clip on:
- the plastic rivet,
- the dashboard side panel,
- the trim (1),
- the door seal,
- Connect the battery (see 80A, Battery, Battery: Removal
- Refitting, 80A-1).
READ NEXT:
VEHICLE WITH KEY
REMOVAL
I - REMOVAL PREPARATION OPERATION
Unclip trim (1).
Remove:
the plasti-rivet (2),
the bolt (3).
Remove the door seal.
Unclip the dashboard side face (4).
VEHICLE WITH CARD
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the centre console (see Centre console:
Removal - Refitting) (MR 393, 57A, Interior equipment).
Unclip the trim at (1) and (2
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lock the airbag computer using the Diagnostic tool
to unlock the steering column lock (see Fault finding
- Replacement of components) (MR 394, 88C,
Airb
SEE MORE:
D4F
Tightening torque (in Nm)
K4J, and JH3
K4M, and JH3
K4M, and DP0
K9K, and JR5
K9K, and JH3
K9K, and TL4
D4F, and JH3
M4R, and DP0
F4R
M4R, and TL4
K9K, and 750 or 760 or 762 or 764 or 766 or 768
High pressure pump
Flow regulation solenoid valve
Pressure regulation solenoid
valve
Diesel temperature sensor
Spacer between the cylinder
head and the injector clamp
Injector clamp
Diesel injector fuel return pipe
Diesel injector
High pre
© 2016-2025 Copyright Renault Clio Owners Club
