Renault Clio: To lock the system

Renault Clio. To lock the system


NB: if the tool kit does not lock in place, check the tightness of nut 3 and the correct positioning of handle 4.

Special features

The emergency spare wheel holder should always be present when you are driving even when the wheel itself is not present: risk of water entering the vehicle.

If you have to release it when it is not holding a wheel, push the centre of the wheel holder towards the ground while pressing handle 4.

It is essential to lock the nut so that the wheel is held securely.

The system should only be used with the original vehicle wheels or identical wheels.

READ NEXT:

 Tyre inflation kit

The kit repairs tyres when tread A has been damaged by objects smaller than 4 mm. It cannot repair all types of puncture, such as cuts larger than 4 mm, or cuts in tyre si

 Tools

The tools included in the tool kit depend on the vehicle. Tool kit A is located in the tray under the luggage compartment carpet. Lift the cover and remove it. Wheelbrace 1 Locks or

 Wheel trims - wheel

Remove the wheel trim using hubcap tool 1 (located in the tool kit) by engaging the hook in the opening near valve 2. To refit it, align it with valve 2. Push the retaining hooks in fully,

SEE MORE:

 Wipers (replacing blades)

Replacing windscreen wiper blades 1 With the ignition off, lift wiper arm 2; turn blade 1. Lower tab 3, by pressing on either side A. Then push the blade forwards B, to release hook 4. To refit To refit the wiper blade, proceed in reverse order to removal. Make sure that t

 Fuel tank: Removal - Refitting

D4F or F4R or K4J or K4M or K9K or M4R - S85 IMPORTANT During this operation, be sure to: be careful of fuel splashes when disconnecting the union. IMPORTANT Wear goggles with side protectors for this operation. IMPORTANT Wear latex gloves during the operation. WARNING To prevent impurities fro

© 2016-2025 Copyright Renault Clio Owners Club