Renault Clio: Radiator mounting cross member: General description
Renault Clio III (2005-2013) Service Manual / Panelwork / Front Lower Structure / Radiator mounting cross member: General description
Note: The information contained in the following describes the general repair procedure for all vehicles having the same design for this part.
Before reading this general information, check that there are no special notes associated with this vehicle.
These special notes will be specified if applicable in other parts of this subsection dealing with the part.
Note: For a detailed description of a particular connection, see MR 400.
DESIGN OF THE STRUCTURAL COMPONENT
This steel part, which bolts onto the front axle subframe, combines two functions:
- distribution of front impact forces,
- radiator support cross member.
Radiator mounting cross member: Removal - Refitting
I - REMOVAL
1 - REMOVAL PREPARATION OPERATION
- Remove the front bumper (see Front bumper: Removal - Refitting).
- Attach the radiator upper section.
- Remove the engine undertray.
2 - OPERATION FOR REMOVAL OF PART CONCERNED
- Remove the mounting bolts (1) from each side.
- Remove the mounting bolt (2) from each side.
II - REFITTING
1 - REFITTING OPERATION FOR PART CONCERNED
- Refit the mounting bolts (1) and (2).
- Torque tighten the
- the mounting bolts (1) (21 Nm),
- mounting bolts (2) (105 Nm).
2 - FINAL OPERATION
- Refit the engine undertray.
- Detach the radiator upper section.
- Refit the front bumper (see Front bumper: Removal - Refitting).
READ NEXT:
Front side member: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure fo
Front side member, centre section: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure fo
Front side member closure panel, front section:
General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure fo
SEE MORE:
Clutch position sensor: Removal - Refitting
K9K, and JA5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
R
Exhaust: Precautions for the repair
I - PARTS AND CONSUMABLES FOR THE REPAIR
1 - Parts always to be replaced:
the exhaust trunking (if fitted)
the seal or sealing ring on the connection between the
catalytic converter or catalytic pre-converter and the
rest of the exhaust system
the exhaust clip(s) (if fitted)
2 - Consumables
