Renault Clio: Rear air distribution duct: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Air Conditioning / Heating / Rear air distribution duct: Removal - Refitting

Renault Clio. Rear air distribution duct: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

Renault Clio. Rear air distribution duct: Removal - Refitting

1 - Rear left-hand air distribution duct

2 - Rear right-hand air distribution duct

II - OPERATION FOR REMOVAL OF PART CONCERNED

1 - Rear left-hand air distribution duct

Renault Clio. Rear air distribution duct: Removal - Refitting

2 - Rear right-hand air distribution duct

Renault Clio. Rear air distribution duct: Removal - Refitting

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

1 - Rear left-hand air distribution duct

Renault Clio. Rear air distribution duct: Removal - Refitting

2 - Rear right-hand air distribution duct

Renault Clio. Rear air distribution duct: Removal - Refitting

II - FINAL OPERATION.

1 - Rear left-hand air distribution duct

2 - Rear right-hand air distribution duct

READ NEXT:

 Recirculation control cable: Removal - Refitting

LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Partially remove seal (1). Remove the side panel (2). Remove the bolt (3) from the base

 Air distribution cable: Removal - Refitting

LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the glovebox (see Glovebox: Removal - Refitting) (MR 393, 57A, Interior equipment),

 Air mixing cable: Removal - Refitting

LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Partially remove seal (1). Remove the side panel (2). Remove the bolt (3) from the base

SEE MORE:

 Injector leak flow: Check

K9K, and 750 or 752 or 764 or 766 or 768 Note: Vehicles equipped with the K9K*768 engine may or may not be equipped with an intercooler. Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Disconnect the inlet pressure sensor (1). Remove the air duct (3) betwee

 Windscreen pillar trim: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Partially remove the seal (1). II - OPERATION FOR REMOVAL OF PART CONCERNED Unclip the top of the pillar trim at (2). remove the pillar trim by pulling upwards. REFITTING I - REFITTING PREPARATIONS OPERATION Check the condition of the clips (3

© 2016-2025 Copyright Renault Clio Owners Club