Renault Clio: Additional methods of restraint
All of the warnings below are given so that the airbag is not obstructed in
any way when it is inflated and also to prevent
the risk of serious injuries caused by items which may be dislodged when it
inflates.
| The airbag is designed to complement the action of the seat belt.
Both the air bags and seat belts are integral parts of
the same protection system. It is therefore essential to wear seat belts
at all times. If seat belts are not worn, the occupants
are exposed to the risk of serious injury in the event of an accident.
It may also increase the risk of minor superficial
injuries occurring when the airbag is deployed, although such minor
injuries are always possible with air bags.
If the vehicle should overturn or in the event of a rear impact, however
severe, the pretensioners and airbags are not always
triggered. Impacts to the underside of the vehicle, e.g. from pavements,
potholes or stones, can all trigger these systems.
- No work or modification whatsoever may be carried out on
any part of the airbag system (airbags, pretensioners, computer,
wiring harness, etc.), except by qualified Network personnel.
- To ensure that the system is in good working order and to
avoid accidental triggering of the system which may cause injury,
only qualified Network personnel may work on the airbag system.
- As a safety precaution, have the airbag system checked if
your vehicle has been involved in an accident, or is stolen or
broken into.
- When selling or lending the vehicle, inform the user of
these points and hand over this handbook with the vehicle.
- When scrapping your vehicle, contact your approved Dealer
for disposal of the gas generator(s).
|
READ NEXT:
Carrying children
Children, and adults, must be correctly
seated and strapped in for all journeys.
The children being carried in your vehicle
are your responsibility.
A child is not a miniatu
Rear-facing child seats
A baby’s head is, proportionally, heavier
than that of an adult and its neck is very
fragile. Transport the child in this position
for as long as possible (until the
SEE MORE:
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting).
Loosen the clip (1) between the air duct and the air
flowmeter.
Disconnect the air flowmeter connector.
Unfasten the air duct and remove it.
Disconnect the air flowmeter connector.
II
Left-hand side
Right-hand side
To replace this part, order the heater bulkhead reinforcement (A) and the
side member expanding insert (B).
There is only one way of replacing this part:
complete replacement.
IMPORTANT
The straightening bench must be used.
I - COMPOSITION OF THE SPARE PART
Left
© 2016-2025 Copyright Renault Clio Owners Club
