Renault Clio: Front side door protective strip: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Mechanisms And Accessories / Exterior Protection / Front side door protective strip: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

Renault Clio. Front side door protective strip: Removal - Refitting

Renault Clio. Front side door protective strip: Removal - Refitting

II - REMOVAL OPERATION FOR PART CONCERNED

Renault Clio. Front side door protective strip: Removal - Refitting

III - REFITTING OPERATION FOR PART CONCERNED

IV - FINAL OPERATION.

Rear side door protective strip: Removal - Refitting

B85 or K85

REMOVAL

I - REMOVAL PREPARATION OPERATION

Renault Clio. Rear side door protective strip: Removal - Refitting

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Rear side door protective strip: Removal - Refitting

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

II - FINAL OPERATION.

C85 or S85

REMOVAL

OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Rear side door protective strip: Removal - Refitting

REFITTING

I - REFITTING PREPARATION OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

Roof protection strip: Removal - Refitting

C85 or S85

REMOVAL

Note: It is possible to replace the access flap for mounting the roof rack bars.

OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Roof protection strip: Removal - Refitting

REFITTING

I - REMOVAL PREPARATION OPERATION

Renault Clio. Roof protection strip: Removal - Refitting

II - FINAL OPERATION.

READ NEXT:

 Front wheel arch liner: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove the front wheel (see Wheel: Removal - R

 Rear bumper: Stripping - Rebuilding

B85 or C85 or S85, and EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2 or EQUIPMENT LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5, and DOCUMENTATION PHASE 1 STRIPPING I - STRIPPING PREPARATION O

 Exterior Equipment

SEE MORE:

 Particle filter temperature sensors: Removal - Refitting

K9K, and 772 The particle filter must be removed in order to remove the catalytic converter upstream temperature sensor. REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02, Lifting equipment). Disconnect the battery (s

 Front side member, centre section: General description

IMPORTANT Use a repair bench to ensure the positioning of the points and the geometry of the axle assemblies. Note: The information contained in the following describes the general repair procedure for all vehicles having the same design for this part. Before reading the following general informati

© 2016-2025 Copyright Renault Clio Owners Club