Renault Clio: Windscreen pillar trim: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Trim And Upholstery / Body Internal Trim / Windscreen pillar trim: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Partially remove the seal (1).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Unclip the top of the pillar trim at (2).
- remove the pillar trim by pulling upwards.
REFITTING
I - REFITTING PREPARATIONS OPERATION
- Check the condition of the clips (3).
II - REFITTING OPERATION FOR PART CONCERNED
- Refit the trim starting from the bottom.
III - FINAL OPERATION.
- Refit the seal (4).
Side roof rail rear trim: Removal - Refitting
C85 or S85
REMOVAL
OPERATION FOR REMOVAL OF PART CONCERNED
- Unclip the rear roof drip moulding lining.
REFITTING
REFITTING OPERATION FOR PART CONCERNED
- Refit the rear roof drip moulding lining.
READ NEXT:
B-pillar upper trim: Removal - Refitting
C85
REMOVAL
REMOVAL PREPARATION OPERATION
Remove:
the complete rear bench seat,
the rear wing panel lining (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32).
B-pillar trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Move the seats fully forward.
Partially remove the frame seals (1).
Partially unclip the front and rear door sill trims.
II - REMOVAL OF PART CONCE
Rear inner sill upper trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the complete rear bench seat.
Partially remove seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the trim at (2) and at (3).
SEE MORE:
Thermostat: Removal - Refitting
M4R
Note:
This engine has two thermostats: one thermostat is
located on the cylinder head and the other is on the
cylinder block.
REMOVAL OF THE CYLINDER HEAD
THERMOSTAT
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lift
Air flowmeter: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting).
Loosen the clip (1) between the air duct and the air
flowmeter.
Disconnect the air flowmeter connector.
Unfasten the air duct and remove it.
Disconnect the air flowmeter connector.
II
© 2016-2025 Copyright Renault Clio Owners Club
