Renault Clio: Wipers (replacing blades)
Replacing windscreen wiper
blades 1

- With the ignition off, lift wiper arm 2;
- turn blade 1.

Lower tab 3, by pressing on either
side A.
Then push the blade forwards B, to release
hook 4.
To refit
To refit the wiper blade, proceed in reverse
order to removal. Make sure that
the blade is correctly locked in position.
Check the condition of the wiper
blades. You are responsible for their
service life:
- clean the blades, windscreen and
rear screen regularly with soapy
water;
- do not use them when the windscreen
or rear screen are dry;
- free them from the windscreen or
rear screen when they have not
been used for a long time.
|
Whilst changing the blade, take care
not to drop the arm onto the window
after it has been removed as this
may break the window. |
Rear screen wiper blade 5

- With the ignition off, lift wiper arm 6;
- release the blade 5 by pulling it.
To refit
To refit the wiper blade, proceed in reverse
order to removal. Make sure that
the blade is correctly locked in position
- In frosty weather, make
sure that the wiper blades
are not stuck by ice (to
avoid the risk of the motor
overheating).
- Check the condition of the wiper
blades.
Replace the wiper blades as soon
as they begin to lose efficiency
(approximately once a year).
Whilst changing the blade, take care
not to drop the arm onto the window
after it has been removed as this
may break the window. |
Check the condition of the wiper
blades. You are responsible for their
service life:
- clean the blades, windscreen and
rear screen regularly with soapy
water;
- do not use them when the windscreen
or rear screen are dry;
- free them from the windscreen or
rear screen when they have not
been used for a long time.
|
READ NEXT:
Before towing, unlock the steering
column: with the clutch depressed,
engage first gear (lever in position N
or R for vehicles with automatic gearboxes),
insert the RENAULT card in the
card reade
With the engine switched off, the transmission
is no longer lubricated. It is
preferable to tow this type of vehicle on
a trailer or tow it with the front wheels
off the ground.
Under exception
Unclip cover 4 or 6 by sliding a flat tool
(or the key integrated in the RENAULT
card) under the cover.
Tighten towing hitch 3 fully: as much
as possible by hand at first, then finish
tight
SEE MORE:
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove:
the air filter unit (see
K9K
WARNING
Always check the oil level using the dipstick.
Do not exceed the maximum level on the dipstick
(could destroy the engine).
Correct the engine oil level if necessary before
delivering the vehicle to the customer.
Note:
When topping up the engine oil, always leave at
least 10 minutes be
© 2016-2025 Copyright Renault Clio Owners Club
