Renault Clio: Rear panel lining: Removal - Refitting
C85 or S85

REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the complete rear bench seat.

- Remove:
- the front seat belt support bolt (1).
- the front seat belt support.

- Unclip:
- the rear section of the front door sill lining (3),
- the rear wing panel trim at (4).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip the rear wing panel trim at (7), (8) and (9).
REFITTING
I - REFITTING PREPARATION OPERATION
- Always replace the front seat belt support bolt.
II - REFITTING OPERATION FOR PART
CONCERNED
- Clip on the rear wing panel trim.
C85

- Refit:
- the speaker,
- the bolts (10).

- Clip on the speaker grille.
III - FINAL OPERATION.
- Clip on the front door sill lining.
- Refit the front seat belt support.
- Torque tighten the front seat belt support bolt (21
Nm).
READ NEXT:
REMOVAL
I - REMOVAL PREPARATION OPERATION
C85
Remove the rear wing panel trim (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32).
B85
Unclip the rear inner sill upper
REMOVAL
I - REMOVAL PREPARATION OPERATION
B85 or C85 or S85
Remove the luggage compartment carpet.
K85
Remove the luggage compartment raised floor (1).
Remove the luggage compartment carpe
S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the rear parcel shelf,
the centre rear parcel shelf (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the clips (2).
Remove
SEE MORE:
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove:
the engine cover,
the engine undertray,
the air filter box air inlet pipe,
JH3 or JR5
Note:
Each time an operation is carried out on the
hydraulic clutch system, bleed the circuit:
between the reservoir and the bleed hole,
between the bleed hole and the clutch release
bearing.
REMOVAL
I - REMOVAL PREPARATION OPERATION
K4J or K4M
Remove the resonator.
Remov
© 2016-2025 Copyright Renault Clio Owners Club
