Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Remove the gearbox (see Automatic gearbox: Removal - Refitting).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Set up the (Mot. 582-01) (2).
• Remove:
  • the bolts (2),
  • the drive plate,
  • tool (Mot. 582-01).

REFITTING

I - REFITTING PREPARATIONS OPERATION

• Check that the drive plate is not damaged (run-out tolerance of 0.2 mm on the outer diameter).

II - REFITTING OPERATION FOR PART CONCERNED

• Fit the drive plate, ensuring it is correctly positioned in relation to the centring pins.
• Apply LOCTITE FRENBLOC to the bolt threads.
• Tighten the bolts on the drive plate.
• Torque and angle tighten the drive plate bolts (55 Nm + 50

  READ NEXT:

   Top And Front Of Engine

   Pressure at end of compression: Check

  K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

   Accessories belt: Removal - Refitting

  K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

  SEE MORE:

    Rigid brake pipe: Repair

  This procedure applies to copper pipes diameter 4.7 mm. Note: This procedure does not apply to: hybrid pipes (pipe + hose), pipes with diameters 6 mm and 8 mm. REPAIR I - PIPE PREPARATION OPERATION WARNING To avoid causing a breakdown in hydraulic brake circuit, do not squash or bend the rigid

    Front brake pads: Removal - Refitting

  EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2 or EQUIPMENT LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG When replacing brake pads, be sure to replace the pads on the opposite side. REMOVAL I - REMOVAL PREPARATION OPERATION Position the