Renault Clio: Card reader: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Engine Immobiliser / Card reader: Removal - Refitting

VEHICLE WITH CARD

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Remove the centre console (see Centre console: Removal - Refitting) (MR 393, 57A, Interior equipment).

• Unclip the trim at (1) and (2).

RADIO NO. 01 or RADIO NO. 02 or RADIO NO.03 or RADIO NO. 04 or RADIO NO. 05 or RADIO NO.06

• Remove the radio (see 86A, Radio, Radio: Removal - Refitting, 86A-8).

NAVIGATION AID 1

• Remove the radio navigation system (see 83C, On-board telematics system, Radio navigation: Removal - Refitting, 83C-3).

WITHOUT NAVIGATION AID, and VEHICLE WITHOUT RADIO

• Unclip the glovebox using the (Car. 1363).

• Unclip the centre front panel at (3).

• Unclip the centre front panel at (4).
• Disconnect the connectors.

II - REMOVAL OPERATION FOR THE PART CONCERNED

• Lift up the card reader at the rear section (5).

• Remove the card reader at (6).

REFITTING

I - REFITTING OPERATING FOR THE PART CONCERNED

• Insert the card reader along the guides.
• Clip on the card reader.

II - FINAL OPERATION.

• Connect the centre front panel connectors.
• Clip in the centre front panel beginning with the lower section.

RADIO NO. 01 or RADIO NO. 02 or RADIO NO. 03 or RADIO NO. 04 or RADIO NO. 05 or RADIO NO.06

• Refit the radio (see 86A, Radio, Radio: Removal - Refitting, 86A-8).

NAVIGATION AID 1

• Refit the radio navigation system (see 83C, On-board telematics system, Radio navigation: Removal - Refitting, 83C-3).

WITHOUT NAVIGATION AID, and VEHICLE WITHOUT RADIO

• Clip the glovebox in position.

• Clip the trim under the centre front panel.
• Refit the centre console (see Centre console: Removal - Refitting) (MR 393, 57A, Interior equipment).

Horn

Audible warning: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Remove the front bumper (see Front bumper: Removal - Refitting) (MR 393, 55A, Exterior protection).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Disconnect the connector (1).
• Remove:
  • the bolt (2),
  • the horn.

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

• Refit the horn.
• Torque tighten the horn bolt (21 Nm) (2).
• Connect the connector (1).

II - FINAL OPERATION.

• Refit the front bumper (see Front bumper: Removal - Refitting) (MR 393, 55A, Exterior protection).

READ NEXT: