Renault Clio: Rear light bulb: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the rear light on the wing (see 81A, Rear
lighting, Rear wing light: Removal - Refitting, 81A-5).
B85 or C85 or S85, and DOCUMENTATION
PHASE 1

- Unclip the bulb holder plate (1) by pressing clips (2) and (3).
K85, and DOCUMENTATION PHASE 1

- Unclip the bulb holder plate by pressing clips (4) and (5).
B85 or C85 or S85, and DOCUMENTATION
PHASE 2

- Unclip the bulb holder plate by pressing on the clips (6).
- Remove the bulb holder plate.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
B85 or C85 or S85, and DOCUMENTATION
PHASE 1

- Brake light and side light bulb
- Reversing light bulb
- Direction indicator bulb
- Rear fog light bulb
- Remove the bulbs from the bulb holders.
Note:
The layout of bulbs is the same for both rear
lights.
K85, and DOCUMENTATION PHASE 1

- Brake light and side light bulb
- Direction indicator bulb
- Reversing light bulb
- Remove the bulbs from the bulb holders.
Note:
The layout of bulbs is the same for both rear
lights.
B85 or C85 or S85, and DOCUMENTATION PHASE 2

- Brake light and side light bulb
- Reversing light bulb
- Direction indicator bulb
- Remove the bulbs from the bulb holders.
Note:
The layout of bulbs is the same for both rear
lights.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
Note:
When replacing a bulb, only use approved bulbs.
- Refit the bulbs on the bulb holder plate.
II - FINAL OPERATION
- Clip the bulb holder plate onto the rear light.
- Refit the rear light on the wing.
READ NEXT:
B85 or C85 or S85
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the blanking covers (1).
Insert a screwdriver in the openings to move the clips (2).
Apply pressure to the clips (2)
K85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the tailgate spoiler (see Tailgate spoiler: Removal - Refitting),
the high level brake light (see 81A, Rear lighting,
3rd brake light: Rem
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
K85, and DOCUMENTATION PHASE 1
Move the rear fog light using the tool (Car. 1363) as a lever at (1).
B85 or C85 or S85, and DOCUMENTATION
PHASE 2
SEE MORE:
K9K, and JA5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Note:
When replacing the electric pump assembly,
always replace the control relay.
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, run command
" Disc
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
WARNING
To prevent damage to the wiring harness when
refitting, observe the original routing.
REMOVAL
I - REMOVAL PR
© 2016-2025 Copyright Renault Clio Owners Club
