Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

Renault Clio. Drive plate: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Drive plate: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

READ NEXT:

 Top And Front Of Engine

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

 Accessories belt: Removal - Refitting

K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

SEE MORE:

 Engine Compartment Connection Unit

Protection and Switching Unit: Removal - Refitting IMPORTANT Never apply pressure to the engine compartment connection unit joint face (risk of moisture entering). If the joint face is damaged, the unit will need to be replaced. REMOVAL I - REMOVAL PREPARATION OPERATION In the event of replaceme

 Automatic gearbox: Identification

DP0 The automatic transmission series number can be found in two places: on a label on the hydraulic distributor cover (1) and etched onto the outer casing (2) on the wheel side. Automatic gearbox oil: Draining - Filling DP0 I - OIL SERVICE Position the vehicle on a two-post lift (see Vehicle:

© 2016-2025 Copyright Renault Clio Owners Club