Renault Clio: Crankshaft position sensor: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Diesel Injection / Crankshaft position sensor: Removal - Refitting
K9K, and 764 or 766 or 768
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting).
- Disconnect the battery (see Battery: Removal - Refitting).
- Remove the engine undertray.
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Disconnect the connector (1) from the engine speed and position sensor.
- Remove the engine speed and position sensor (2).
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit the engine speed and position sensor.
- Connect the engine speed and position sensor connector.
II - FINAL OPERATION
- Refit the engine undertray.
- Connect the battery (see Battery: Removal - Refitting).
K9K, and 750 or 752
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the air filter unit air inlet pipe.
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Disconnect the connector (1) from the engine speed and position sensor.
- Remove:
- the engine speed and position sensor bolts (2),
- the engine speed and position sensor.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit:
- the speed and position sensor,
- the engine speed and position sensor bolts.
- Connect the engine speed and position sensor connector.
II - FINAL OPERATION
- Refit the air filter unit air inlet pipe.
READ NEXT:
Pre-postheating unit: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the battery (see Battery: Removal - Refitting),
the battery tray (see Battery tray: Removal - Refitting)
(MR 392, 80A, Battery).
II
Heater plugs: Removal - Refitting
K9K, and 764 or 772
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the air filter box inlet air pipe (1).
Remove the turbocharger outlet air pipe retaining pins (2).
Remove:
the turbochar
SEE MORE:
Automatic gearbox: Identification
DP0
The automatic transmission series number can be
found in two places: on a label on the hydraulic distributor
cover (1) and etched onto the outer casing (2) on
the wheel side.
Automatic gearbox oil: Draining - Filling
DP0
I - OIL SERVICE
Position the vehicle on a two-post lift (see Vehicle:
Particle filter temperature sensors: Removal -
Refitting
K9K, and 772
The particle filter must be removed in order to remove
the catalytic converter upstream temperature sensor.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02, Lifting equipment).
Disconnect the battery (s
© 2016-2025 Copyright Renault Clio Owners Club
