Renault Clio: Fuses
Fuses: List and location of components
- Passenger compartment fuse and relay box
- Consumer cut-out fuse
- Additional relay/fuse box
- Battery protection fuses
- Protection and switching unit
- Power supply fuse board
- Optional relay unit
I - PASSENGER COMPARTMENT FUSE AND RELAY BOX
LEFT-HAND DRIVE
Open the access flap to gain access to the unit.
RIGHT-HAND DRIVE
Open the access flap to gain access to the unit.
II - CONSUMER CUT-OUT FUSE
LEFT-HAND DRIVE
RIGHT-HAND DRIVE
III - ADDITIONAL FUSE AND RELAY BOX
LEFT-HAND DRIVE
Remove the glovebox (see Glovebox: Removal - Refitting) (MR 393, 57A, Interior equipment) to access the box.
RIGHT-HAND DRIVE
Remove the lower dashboard trim (see Dashboard: Removal - Refitting) (MR 393, 57A, Interior equipment) to access the box.
IV - BATTERY PROTECTION FUSES
This box is located on the positive battery terminal.
V - PROTECTION AND SWITCHING UNIT
This box is located in the engine compartment, behind the left headlamp.
Remove the cover to gain access to the unit.
VI - POWER SUPPLY FUSE BOARD
This box is located on the front panel of the battery tray.
Remove the cover to gain access to the unit.
VII - OPTIONAL RELAY UNIT
This box is located on the engine-side panel of the battery tray.
Remove the cover to gain access to the unit.
READ NEXT:
Immobiliser system: List and location of components
I - LIST OF COMPONENTS
II - LOCATION OF COMPONENTS
VEHICLE WITH KEY
1 - Antenna/Transponder ring
2 - Ignition switch
3 - UCH
4 - Key
VEHICLE WITH CARD
5 - Front starting aerial
6 - Central start
Ignition switch: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting, 80A-1).
Unclip trim (1).
Remove:
the plastic rivet (2),
bolt (3).
SEE MORE:
Fitting a radio
Radio location 1
Unclip the blanking cover. The aerial, +
and – supply and speaker wire connections
are located behind it.
Door speakers 2
To install any equipment, please consult
an authorised dealer.
In all cases, it is very important to
follow the manufacturer
Steering column adjustment handle: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting).
Remove:
the mounting clips (1) on the lower trim of the driver's
side dashboard,
the lower trim (2) of the driver's side dashboard.
Remove:
the bolt-cover protective strip,
the i
