Renault Clio: Reverse gear switch: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Transmission / Manual Gearbox / Reverse gear switch: Removal - Refitting
TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the battery (see Battery: Removal - Refitting) (80A, Battery),
- the battery tray (see Battery tray: Removal - Refitting) (80A, Battery).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Disconnect the connector (1) from the reverse gear switch.
- Remove the reverse gear switch using the socket for removing/refitting the reverse gear switch (Bvi.1934) (2).
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit the reverse gear switch.
- Tighten the reverse gear switch using the socket for removing/refitting the reverse gear switch (Bvi.1934).
- Connect the reverse gear switch connector.
II - FINAL OPERATION
- Refit:
- the battery tray (see Battery tray: Removal - Refitting) (80A, Battery),
- the battery (see Battery: Removal - Refitting) (80A, Battery).
JH3 or JR5
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).
- Remove the engine undertray.
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Disconnect the connector (1) from the reverse gear switch.
- Remove the reverse gear switch (2) using the (Bvi.1934).
Note: Seal the housing of the reverse gear switch while replacing the part.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Apply some SILICONE ADHESIVE SEALANT (see Vehicle: Parts and consumables for the repair) (04B, Consumables - Products) to the threading of the reverse gear switch.
- Refit the reverse gear switch using the (Bvi. 1934).
- Torque tighten the reverse gear switch (23 N.m).
- Connect the reverse gear switch connector.
II - FINAL OPERATION
- Fill the gearbox (see 21A, Manual gearbox, Manual gearbox oils: Draining - Filling, 21A-3).
- Refit the engine undertray.
READ NEXT:
Sequential gearbox: Precautions for the repair
D4F or K9K, and JA3 or JA5
I - SEQUENTIAL GEARBOX
WARNING
If any operation is carried out on the electro-hydraulic
unit, it is essential to clean the unit using a cleaning
product and compressed air.
Pump assembly reservoir: Removal - Refitting
K9K, and JA5
REMOVAL
I - REMOVAL PREPARATION OPERATION
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, ru
SEE MORE:
Wipers (replacing blades)
Replacing windscreen wiper
blades 1
With the ignition off, lift wiper arm 2;
turn blade 1.
Lower tab 3, by pressing on either
side A.
Then push the blade forwards B, to release
hook 4.
To refit
To refit the wiper blade, proceed in reverse
order to removal. Make sure that
t
Brake servo non-return valve: Removal - Refitting
LEFT-HAND DRIVE
REMOVAL
I - REMOVAL PREPARATION OPERATION
K4J or K4M or K9K
Remove the engine cover.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Disconnect the non-return valve (1) at the servo.
Pull and turn the non-return valve to release it from
the rubber sealing washer.
K9K
Disconn
© 2016-2025 Copyright Renault Clio Owners Club
