Renault Clio: Charge circuit: Specifications
D4F or F4R or K4J or K4M or K9K or M4R
ALTERNATOR SPECIFICATIONS

Charge circuit: Function
D4F or F4R or K4J or K4M or K9K or M4R
OPERATION
These vehicles are fitted with a built-in regulator and an
instrument panel warning light which operates as follows:
- when the ignition is switched on, the warning light
comes on,
- the warning light goes out when the vehicle is started,
- if the warning light comes on while the engine is running,
it indicates a battery charge fault.
Charge circuit: Check
D4F or F4R or K4J or K4M or K9K or M4R
Check the current after 30 minutes of heating at a voltage of 13.5 V.





READ NEXT:
K4J, and STANDARD HEATING - K4M, and STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
Remove the air inlet
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove the air filter unit (see 12A, Fuel mi
SEE MORE:
Note:
In the event of a front impact with triggering of airbags,
check the area of connection between both
diameters of the beam. If there is any damage visible
to the naked eye, this part must be replaced.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the front doors (see 47A, Side opening
AIR CONDITIONING or CLIMATE CONTROL
Note:
The evaporator is supplied already assembled in
the distribution unit. (1)
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the distribution unit (see 61A, Heating,
Distribution unit: Removal - Refitting, 61A- 50).
REFITTING
REFITTING OPERATION FO
© 2016-2025 Copyright Renault Clio Owners Club
