{MAINCONT}

Renault Clio: High level brake light bulb: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Rear Lighting / High level brake light bulb: Removal - Refitting

K85

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. High level brake light bulb: Removal - Refitting

Note: When replacing bulbs, use approved W5W bulbs.

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

II - FINAL OPERATION.

B85 or C85 or S85

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. High level brake light bulb: Removal - Refitting

Note: When replacing the bulb, use an approved W16W bulb.

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

II - FINAL OPERATION.

READ NEXT:

 Rear fog lights: Removal - Refitting

REMOVAL OPERATION FOR REMOVAL OF PART CONCERNED K85, and DOCUMENTATION PHASE 1 Move the rear fog light using the tool (Car. 1363) as a lever at (1). B85 or C85 or S85, and DOCUMENTATION PHASE 2

 Interior Lighting

Interior lighting: Function I - GENERAL INFORMATION Vehicles may be fitted with the following units for lighting the interior of the passenger compartment, depending on the level of equipment: a cou

 Fuses

Fuses: List and location of components Passenger compartment fuse and relay box Consumer cut-out fuse Additional relay/fuse box Battery protection fuses Protection and switching unit Power sup

SEE MORE:

  Fuel flow: Check

D4F or K4J or K4M or M4R IMPORTANT During this operation, be sure to: be careful of fuel splashes when disconnecting the union. IMPORTANT Wear goggles with side protectors for this operation. IMPORTANT Wear leaktight gloves (Nitrile type) for this operation. WARNING To avoid any corrosion or da

  Diesel injection: Precautions for the repair

K9K I - RISKS RELATING TO CONTAMINATION The high-pressure direct injection system is highly sensitive to contamination. The risks caused by contamination are: damage to or destruction of the high pressure injection system, a component seizing, a component not being properly sealed. All After-S

{VIDEOCONT}
© 2016-2026 Copyright Renault Clio Owners Club - 0.0038