Renault Clio: Pressure sensor: Removal - Refitting

DP0

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Position the vehicle on the two-post lift (see 02A, Lifting equipment, Vehicle: Towing and lifting).
• Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting).
• Remove:
  • the front left-hand wheel (see 35A, Wheels and tyres, Wheel: Removal - Refitting),
  • the front left-hand wheel arch liner (see MR Bodywork, 55A, Exterior protection, Wheel arch liner: Removal - Refitting),
  • the engine undertray.
• Remove:
  • the battery tray (see 80, Battery, Battery tray: Removal - Refitting),
  • the air filter unit (see 12A, Fuel mixture, Air filter unit: Removal - Refitting).

• Disconnect the modular connector (1) by pulling the sliding (2).

• Disconnect the gearbox connector from the mounting plate by pulling the slide (3).
• Remove the gearbox connector mounting bolts (4) from the plate.

• Remove the green connector (3-track) (5) from the gearbox connector on the mounting plate.
• Release the pressure sensor wiring harness from the automatic transmission wiring duct.

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Remove:
  • the wiring harness mounting bolt (6),
  • the pressure sensor mounting bolts (7),
  • the pressure sensor (8).

WARNING

Protect the connector by sliding it into a waterproof plastic bag.

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

• Refit:
  • the pressure sensor,
  • the pressure sensor mounting bolts,
  • the wiring harness mounting bolt.
• Tighten to torque:
  • the pressure sensor mounting bolts (8 N.m),
  • the pressure sensor wiring harness mounting bolts (8 N.m).
• Connect the pressure sensor harness from the automatic transmission wiring duct.

II - FINAL OPERATION

• Refit the gearbox connector mounting plate mounting bolts.
• Torque tighten the gearbox connector mounting bolts (20 N.m).
• Connect the gearbox connector on the mounting plate by pulling out the slide.
• Refit:
  • the air filter unit (see 12A, Fuel mixture, Air filter unit: Removal - Refitting),
  • the battery protective base (see 80A, Battery, Battery tray: Removal - Refitting),
• Connect the modular connector by reinserting the slide.
• Refit the battery shield (see 80A, Battery, Battery tray: Removal - Refitting).
• Refit:
  • the front left-hand wheel arch liner (see 55A, Bodywork, Exterior protection, Wheel arch liner: Removal - Refitting),
  • the engine undertray,
  • the front left-hand wheel (see 35A, Wheels and tyres, Wheel: Removal - Refitting).
• Connect the battery (see 80A, Battery, Battery: Removal - Refitting).
• Check the gearbox oil level (see 23A, Gearbox oil: Draining - Filling).

READ NEXT: