Renault Clio: Emergency spare wheel
Renault Clio IV (2014-2019) Owners Manual / Practical advice / Puncture, emergency spare wheel / Emergency spare wheel
- Open the tailgate;
- lift the carpet;
- lift the cover 1 and remove it;
- remove the tool kit by lifting it by its handles;
| The label 2 reminds you of how to operate the emergency spare wheel winch. |
- unscrew nut 3 in an anti-clockwise
direction until it comes off completely,
then place the palm of your
hand on section A of handle 4 and
push towards the front of the vehicle.
The wheel will be lowered;
| When you push handle 4,
the wheel will drop under
the vehicle; risk of injury. Ensure that everybody is kept away from the underside of the vehicle. |
- pull the wheel towards you;
- lay the wheel down flat and unfasten cable 5 from its housing 6.
You may remove the wheel from its support.
| Do not touch the exhaust as it could burn. |
READ NEXT:
To refit a wheel
A wheel size larger than 15” cannot
be installed under the vehicle.
To carry out this operation, the cable
must be unwound.
If the cable has been wound back up on
its ow
To lock the system
Press nut 3, screwing it on fully until
it locks in place. Several turns will
be necessary. This operation is essential
to ensure that the wheel is
secure;
return handle 4 to its orig
Tyre inflation kit
The kit repairs tyres when
tread A has been damaged
by objects smaller
than 4 mm. It cannot repair
all types of puncture, such as cuts
larger than 4 mm, or cuts in tyre
si
SEE MORE:
Automatic gearbox converter: Removal - Refitting
DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the front left-hand wheel arch liner (see
Front wheel arch liner: Removal - Refitting) (MR
393, 55A, Exterior protection).
Remove the resonator on the battery.
Disconnect the battery (see ) (MR 392, 80A, Battery).
II - OPERATION FOR REMOVAL
Driveshaft: Precautions for the repair
DP0 or JH3 or JR5 or TL4
WARNING
A gearbox oil leak at the driveshaft may destroy it.
WARNING
Always replace seals whenever the driveshaft is
removed.
WARNING
Grease the base of the bearing using BR 2 +
grease to prevent the bearing from sticking.
Make sure that the O-ring is correctly positioned i
© 2016-2026 Copyright Renault Clio Owners Club - 0.0035
