Renault Clio: Battery for remote door locking control: Removal - Refitting
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
VEHICLE WITH KEY


- Open the key with a coin (2).
VEHICLE WITH CARD

- Remove the mechanical insert (3).
REFITTING
I - REFITTING PREPARATION OPERATION
WARNING
To ensure that the remote control operates correctly,
take care not to damage the battery contacts.
Only handle the new battery with dry, grease-free
hands or wearing clean gloves to avoid any risk
of dirt and oxidation on the battery.
II - REFITTING OPERATION FOR PART
CONCERNED
VEHICLE WITH KEY

- Replace the battery (4) using a flat-blade screwdriver.
VEHICLE WITH CARD

III - FINAL OPERATION.
VEHICLE WITH KEY
- Close the key.
- Tighten the bolt (1).
VEHICLE WITH CARD
- Refit the mechanical insert (6).
READ NEXT:
VEHICLE WITH CARD
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the centre console (see Centre console:
Removal - Refitting) (MR 393, 57A, Interior equipment).
Unclip the trim at (1) and (2
Clock: Before/after repair procedure
SETTING THE CLOCK
WITHOUT NAVIGATION AID, and RADIO NO. 01
or RADIO NO. 02 or RADIO NO. 03 or RADIO NO.
04 or RADIO NO. 05 or RADIO NO. 06 or RADIO
NO. 07 or RADIO
SEE MORE:
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general informati
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the engine cover,
the engine undertray bolts,
the engine undertray,
the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and
© 2016-2025 Copyright Renault Clio Owners Club
