Renault Clio: Crankshaft position sensor: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Diesel Injection / Crankshaft position sensor: Removal - Refitting
K9K, and 764 or 766 or 768
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting).
- Disconnect the battery (see Battery: Removal - Refitting).
- Remove the engine undertray.
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Disconnect the connector (1) from the engine speed and position sensor.
- Remove the engine speed and position sensor (2).
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit the engine speed and position sensor.
- Connect the engine speed and position sensor connector.
II - FINAL OPERATION
- Refit the engine undertray.
- Connect the battery (see Battery: Removal - Refitting).
K9K, and 750 or 752
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the air filter unit air inlet pipe.
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Disconnect the connector (1) from the engine speed and position sensor.
- Remove:
- the engine speed and position sensor bolts (2),
- the engine speed and position sensor.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit:
- the speed and position sensor,
- the engine speed and position sensor bolts.
- Connect the engine speed and position sensor connector.
II - FINAL OPERATION
- Refit the air filter unit air inlet pipe.
READ NEXT:
Pre-postheating unit: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the battery (see Battery: Removal - Refitting),
the battery tray (see Battery tray: Removal - Refitting)
(MR 392, 80A, Battery).
II
Heater plugs: Removal - Refitting
K9K, and 764 or 772
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the air filter box inlet air pipe (1).
Remove the turbocharger outlet air pipe retaining pins (2).
Remove:
the turbochar
SEE MORE:
Front seat base trim: Removal - Refitting
WITHOUT SPORT SEATS, and DOCUMENTATION PHASE 1
IMPORTANT
Before carrying out any work on a safety or proximity
system component, lock the airbag computer
using the Diagnostic tool. When this
function is activated, all the trigger lines are disabled
and the airbag instrument panel warning
light is c
Navigation computer: Removal - Refitting
NAVIGATION AID 1 LEVEL
REMOVAL
I - REMOVAL PREPARATION OPERATION
If the "computer - navigation screen" is being replaced,
carry out the necessary operations using the
Diagnostic tool (see Fault finding - Replacement
of components) (86C, Navigation).
Switch off the ignition.
WARNING
To preven
© 2016-2025 Copyright Renault Clio Owners Club
