Renault Clio: Front wheel arch liner: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
- Remove the front wheel (see Wheel: Removal - Refitting)
(MR 392, 35A, Wheels and tyres).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the bolts (1).
- Remove the clips (2).
- Remove:
- the bolt (3),
- the front wheel arch liner starting at the front section.
REFITTING
I - REFITTING PREPARATION OPERATION
- Check the condition of the clips and replace them if
necessary.
II - REFITTING OPERATION FOR PART
CONCERNED
- Refit:
- the front wheel arch liner starting at the rear section,
- the clips,
- the bolts.
III - FINAL OPERATION.
- Refit the front wheel (see Wheel: Removal - Refitting)
(MR 392, 35A, Wheels and tyres).
Rear wheel arch liner: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
- Remove the rear wheel (see Wheel: Removal - Refitting)
(35A, Wheels and tyres).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

B85 or C85 or S85, and EQUIPMENT LEVEL E3
LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT
LEVEL EA2 or EQUIPMENT LEVEL EA3 or
EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL
EA5 or EQUIPMENT LEVEL EAC or EQUIPMENT
LEVEL SPORT

- Remove:
- the bolts (2),
- the rear wheel arch liner.
K85, and EQUIPMENT LEVEL EAC or EQUIPMENT
LEVEL SPORT

- Remove:
- the bolts (3),
- the rear wheel arch liner.
EQUIPMENT LEVEL EAG

- Remove:
- the bolts (4),
- the rear wheel arch liner.
REFITTING
I - REFITTING PREPARATION OPERATION
- Check the condition of the clipsand replace them if
necessary.
II - REFITTING OPERATION FOR PART
CONCERNED
- Refit:
- the rear wheel arch liner,
- the bolts,
- the clips.
III - FINAL OPERATION
- Refit the rear wheel (see Wheel: Removal - Refitting)
(35A, Wheels and tyres).
READ NEXT:
B85 or C85 or S85, and EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2 or
EQUIPMENT LEVEL EA3 or
EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5, and DOCUMENTATION PHASE 1
STRIPPING
I - STRIPPING PREPARATION O
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the wiper arms (see Windscreen wiper
arm: Removal - Refitting) (MR 392, Mechanical
systems, 85A, Washing - Wiping).
Remove the seal (1).
II -
SEE MORE:
K9K
K9K, and 764 or 766 or 768 or 772
First fitting of the exhaust gas cooler recirculation
assembly
(1) Exhaust gas recirculation solenoid
valve
(2) Exhaust gas cooler
(3) Exhaust gas inlet pipe
(4) Metal air inlet tube
(5) Cooler support on the flywheel
end
(6) Cooler support on the timing
side
S
With the engine switched off and on
level ground, the level when cold must
be between the MINI and MAXI marks
on reservoir 1.
Top this level up when cold before it
reaches the MINI mark.
When working in the engine
compartment, ensure that
the windscreen wiper stalk
is in
© 2016-2025 Copyright Renault Clio Owners Club
