Renault Clio: Pre-postheating unit: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Preheating / Pre-postheating unit: Removal - Refitting

K9K

Renault Clio. Pre-postheating unit: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Pre-postheating unit: Removal - Refitting

Renault Clio. Pre-postheating unit: Removal - Refitting

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

II - FINAL OPERATION.

READ NEXT:

 Heater plugs: Removal - Refitting

K9K, and 764 or 772 REMOVAL I - REMOVAL PREPARATION OPERATION Remove the air filter box inlet air pipe (1). Remove the turbocharger outlet air pipe retaining pins (2). Remove: the turbochar

 Antipollution

 Exhaust gas recirculation: List and location of components

K9K K9K, and 764 or 766 or 768 or 772 First fitting of the exhaust gas cooler recirculation assembly (1) Exhaust gas recirculation solenoid valve (2) Exhaust gas cooler (3) Exhaust gas inlet pipe (4)

SEE MORE:

 Rear Upper Structure

Rear wing panel: General description Note: The information contained in the following describes the general repair procedure for all vehicles having the same design for this part. Before reading the following general information, make sure that there are no special notes associated with the vehicle

 Front driveshaft lower arm: Removal - Refitting

EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2 or EQUIPMENT LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG WARNING Do not use the lower arm for support with a lifting system. REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle

© 2016-2025 Copyright Renault Clio Owners Club