Renault Clio: Radiator mounting cross member: General description
Renault Clio III (2005-2013) Service Manual / Panelwork / Front Lower Structure / Radiator mounting cross member: General description
Note: The information contained in the following describes the general repair procedure for all vehicles having the same design for this part.
Before reading this general information, check that there are no special notes associated with this vehicle.
These special notes will be specified if applicable in other parts of this subsection dealing with the part.
Note: For a detailed description of a particular connection, see MR 400.
DESIGN OF THE STRUCTURAL COMPONENT
This steel part, which bolts onto the front axle subframe, combines two functions:
- distribution of front impact forces,
- radiator support cross member.
Radiator mounting cross member: Removal - Refitting
I - REMOVAL
1 - REMOVAL PREPARATION OPERATION
- Remove the front bumper (see Front bumper: Removal - Refitting).
- Attach the radiator upper section.
- Remove the engine undertray.
2 - OPERATION FOR REMOVAL OF PART CONCERNED
- Remove the mounting bolts (1) from each side.
- Remove the mounting bolt (2) from each side.
II - REFITTING
1 - REFITTING OPERATION FOR PART CONCERNED
- Refit the mounting bolts (1) and (2).
- Torque tighten the
- the mounting bolts (1) (21 Nm),
- mounting bolts (2) (105 Nm).
2 - FINAL OPERATION
- Refit the engine undertray.
- Detach the radiator upper section.
- Refit the front bumper (see Front bumper: Removal - Refitting).
READ NEXT:
Front side member: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure fo
Front side member, centre section: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure fo
Front side member closure panel, front section:
General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure fo
SEE MORE:
Lower cover: Removal -
Refitting
K9K
REMOVAL
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the resonator on the battery,
the battery covers.
Disconnect the battery (see Battery: Removal - Refitting)
(80A, Battery).
Remove the engine undertray.
Drain the
Oil vapour rebreathing circuit: Descriptions
K4J or K4M, and 780 or 800 or 801
Oil vapour rebreathing duct
Calibrated port
Oil vapour recovery plate
located on the rocker cover
Oil vapour rebreathing hole
Oil vapour rebreathing circuit: Operating diagram
K4J, and 780 - K4M, and 800 or 801
A: under low loads, the oil vapours are rebr
