Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

Renault Clio. Drive plate: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Drive plate: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

READ NEXT:

 Top And Front Of Engine

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

 Accessories belt: Removal - Refitting

K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

SEE MORE:

 Clutch thrust bearing: Removal - Refitting

The thrust bearing is connected to the clutch slave cylinder. REMOVAL I - REMOVAL PREPARATION OPERATION Drain the brake reservoir using a syringe to remove the clutch thrust bearing and control. Remove the gearbox (see 21A, Manual gearbox, Manual gearbox: Removal - Refitting, 21A- 12). II - R

 K9K, and 750 or 752 or 766 or 768

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment). Remove: the engine undertray, the radiator mounting cross member bolt on the right-hand side, the sub-frame tie-rod bolt on the left-hand side.

© 2016-2025 Copyright Renault Clio Owners Club