Renault Clio: Headlight: Removal - Refitting

DISCHARGE LAMPS, and DOCUMENTATION PHASE 1

IMPORTANT

To prevent eye injuries:

IMPORTANT

To prevent burns, wait until the " computers - power unit " assemblies are cold before removal.

REMOVAL

I - REMOVAL PREPARATION OPERATION

DISCHARGE LAMPS, and DOCUMENTATION PHASE 1

 

II - OPERATION FOR REMOVAL OF PART CONCERNED

DOCUMENTATION PHASE 1

Renault Clio. Headlight: Removal - Refitting

Renault Clio. Headlight: Removal - Refitting

DOCUMENTATION PHASE 2

Renault Clio. Headlight: Removal - Refitting

Renault Clio. Headlight: Removal - Refitting

 

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

II - FINAL OPERATION

DISCHARGE LAMPS, and DOCUMENTATION PHASE 1

 

READ NEXT:

 Headlight: Adjustment

DOCUMENTATION PHASE 1 ADJUSTMENT I - PREPARATION OPERATION FOR CHECK Place the vehicle in a working area equipped with a two-post lift. Note: Check that the lift is on flat, horizontal ground.

 Headlight bulb: Removal - Refitting

DOCUMENTATION PHASE 1 REMOVAL DISCHARGE LAMPS IMPORTANT To prevent eye injuries: do not look at a xenon bulb when lit (voltage when lit 20000 V), do not light a bulb which has not been fitted into

 Remote headlight beam adjustment actuator: Removal - Refitting

DOCUMENTATION PHASE 1 DISCHARGE LAMPS IMPORTANT To prevent burns, wait until the " computers - power unit " assemblies are cold before removal. IMPORTANT To prevent eye injuries: do not look at a xe

SEE MORE:

 Rear Seat Frames And Mechanisms

Single unit rear bench seatback: Removal - Refitting REMOVAL I - REMOVAL PREPARATION OPERATION Remove the single unit rear bench seat base (see 76A, Rear seat frames and mechanisms, Single unit rear bench seat base: Removal - Refitting, 76A-6). II - OPERATION FOR REMOVAL OF PART CONCERNED R

 Injector leak flow: Check

K9K, and 750 or 752 or 764 or 766 or 768 Note: Vehicles equipped with the K9K*768 engine may or may not be equipped with an intercooler. Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Disconnect the inlet pressure sensor (1). Remove the air duct (3) betwee

© 2016-2025 Copyright Renault Clio Owners Club