Renault Clio: Charge circuit: Specifications

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Starting - Charging / Charge circuit: Specifications

D4F or F4R or K4J or K4M or K9K or M4R

ALTERNATOR SPECIFICATIONS

Renault Clio. Charge circuit: Specifications

Charge circuit: Function

D4F or F4R or K4J or K4M or K9K or M4R

OPERATION

These vehicles are fitted with a built-in regulator and an instrument panel warning light which operates as follows:

when the ignition is switched on, the warning light comes on,
the warning light goes out when the vehicle is started,
if the warning light comes on while the engine is running, it indicates a battery charge fault.

Charge circuit: Check

D4F or F4R or K4J or K4M or K9K or M4R

Check the current after 30 minutes of heating at a voltage of 13.5 V.

Renault Clio. Charge circuit: Check

SEE MORE:

K9K, and JH3 or JR5 or TL4

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment). Remove the front engine cover. K9K, and 772 Discharge the pressure in the fuel supply circuit of the exhaust fuel injector (see 19B, Exhaust, Exhaust

Opening Element Management

Opening elements management: List and location of components UCH Renault card (simple or hands-free) Key equipped with remote control locking Locking - unlocking motor Specific reception receivers in the handles and the rear bumper Proximity and movement sensor Locking button on the handl

Renault Clio: Charge circuit: Specifications

READ NEXT:

Alternator: Removal - Refitting

Starter: Removal - Refitting

Ignition

SEE MORE:

K9K, and JH3 or JR5 or TL4

Opening Element Management