Renault Clio: Access to towing points

Unclip cover 4 or 6 by sliding a flat tool
(or the key integrated in the RENAULT
card) under the cover.
Tighten towing hitch 3 fully: as much
as possible by hand at first, then finish
tightening it using the wheelbrace or,
depending on the vehicle, the lever.
Only use the towing eye 3 and the
wheelbrace located under the luggage
compartment carpet in the tool kit
(please refer to the information under
“Tools” in Section 5).
Do not leave the tools unsecured
inside the vehicle as
they may come loose under
braking. |
READ NEXT:
The following advice will enable you to carry out quick, temporary repairs.
For safety reasons you should always contact
an approved Dealer as soon as possible.
Using the RENAULT card
The Renault Clio IV, produced from 2014 to 2019, offers a range of technical specifications that contribute to its performance and versatility. It is available with gasoline and diesel engine options,
The information shown on the vehicle
identification plate should be
quoted on all correspondence or
orders.
The presence and location of the information
depends on the vehicle.
Vehic
SEE MORE:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove the front engine cover.
K9K, and 772
Discharge the pressure in the fuel supply circuit of
the exhaust fuel injector (see 19B, Exhaust, Exhaust
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove:
the air filter box (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, 12A-17),
the intake distributor (see 12A, Fuel mixture, Inlet
distributor:
© 2016-2025 Copyright Renault Clio Owners Club
