Renault Clio: Charge circuit: Specifications

D4F or F4R or K4J or K4M or K9K or M4R

ALTERNATOR SPECIFICATIONS

Renault Clio. Charge circuit: Specifications

Charge circuit: Function

D4F or F4R or K4J or K4M or K9K or M4R

OPERATION

These vehicles are fitted with a built-in regulator and an instrument panel warning light which operates as follows:

Charge circuit: Check

D4F or F4R or K4J or K4M or K9K or M4R

Check the current after 30 minutes of heating at a voltage of 13.5 V.

Renault Clio. Charge circuit: Check

Renault Clio. Charge circuit: Check

Renault Clio. Charge circuit: Check

Renault Clio. Charge circuit: Check

Renault Clio. Charge circuit: Check

READ NEXT:

 Alternator: Removal - Refitting

K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). Remove the air inlet

 Starter: Removal - Refitting

D4F, and 740 or 742 or 764 REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove the air filter unit (see 12A, Fuel mi

 Ignition

SEE MORE:

 Rear right-hand side door wiring: Removal - Refitting

B85 or K85 IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5). REMOVAL I - REMOVAL PREPARATION OPERATION Raise the window fully. Switch off the ignition. Disconnect

 Soundproofing

Bonnet soundproofing: Removal - Refitting REMOVAL REMOVAL OPERATION FOR PART CONCERNED Remove clips (1) using a pair of unclipping pliers. Remove the bonnet soundproofing. REFITTING REFITTING OPERATION FOR PART CONCERNED Reposition the bonnet soundproofing. Refit the clips (replacing if nece

© 2016-2025 Copyright Renault Clio Owners Club