Renault Clio: Cabin filter: Removal - Refitting
LEFT-HAND DRIVE
Note:
The cabin filter is located in the passenger side A-pillar.
REMOVAL
I - REMOVAL PREPARATION OPERATION
SCHOOL VEHICLE
- Remove the clutch pedal (see Clutch pedal: Removal
- Refitting) (MR392, 37A, Mechanical component
controls).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip the passenger compartment filter at (1).
- Remove the cabin filter.
Note:
Foreign bodies (leaves, insects etc.) are likely to
accumulate in the cabin filter. Remove the cabin
filter with care so as to prevent foreign bodies
getting into the evaporator.
REFITTING
I - REFITTING PREPARATION OPERATION
- Check for foreign bodies in the passenger compartment
filter housing, and clean thoroughly if necessary.
II - REFITTING OPERATION FOR PART
CONCERNED
- Engage the upper section of the base of the filter into
the distribution unit.
- Clip the lower section of the filter base onto the distribution
unit.
III - FINAL OPERATION
SCHOOL VEHICLE
- Refit the clutch pedal (see Clutch pedal: Removal -
Refitting) (MR 392, 37A, Mechanical component
controls).
RIGHT-HAND DRIVE
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip the passenger compartment filter at (1).
Note:
Foreign bodies (leaves, insects etc.) are likely to
accumulate in the passenger compartment filter.
Remove the filter with care so as to prevent foreign
bodies getting into the evaporator.
- Remove the passenger compartment filter.
REFITTING
I - REFITTING PREPARATION OPERATION
- Check for foreign bodies in the cabin filter housing,
and clean thoroughly if necessary.
II - REFITTING OPERATION FOR PART
CONCERNED

READ NEXT:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components)
(MR 394, 88C, Airbags and pretensioners).
Disconnect
LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Partially remove seal (1).
Remove the side panel (2).
Remove the bolt (3) from the base
LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the glovebox (see Glovebox: Removal - Refitting)
(MR 393, 57A, Interior equipment),
SEE MORE:
I - PREREQUISITES FOR WHEEL BALANCING
Wheel balancing is a measurement operation.
Several conditions must be met to achieve a reliable
result in a single operation.
The wheel balancer must be installed in accordance
with the manufacturer's instructions.
It is essential to calibrate the bala
SCHOOL VEHICLE
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
1 - student side
Remove:
the brake light switch (1) (see 37A, Mechanical
component controls, Brake pedal
© 2016-2025 Copyright Renault Clio Owners Club
