Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

Renault Clio. Drive plate: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Drive plate: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

READ NEXT:

 Top And Front Of Engine

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

 Accessories belt: Removal - Refitting

K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

SEE MORE:

 K9K, and JH3 or JR5 or TL4

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment). Remove the front engine cover. K9K, and 772 Discharge the pressure in the fuel supply circuit of the exhaust fuel injector (see 19B, Exhaust, Exhaust

 Silencer: Removal - Refitting

D4F or K4J or K4M or K9K or M4R REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Cut the exhaust pipe (see 19B, Exhaust, Exhaust: Precautions for the repair, 19B-19) (see ) (MR 392, 19A, Exhau

© 2016-2025 Copyright Renault Clio Owners Club