Renault Clio: Front side door protective strip: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION

- Unclip the blanking cover (1).
- Remove the bolt.

- Remove the side mounted indicator (2) using a small
flat screwdriver.
- Disconnect the power supply connector.
II - REMOVAL OPERATION FOR PART
CONCERNED

- Slide the door rubbing strip towards the rear of the
vehicle.
III - REFITTING OPERATION FOR PART
CONCERNED
- Slide the door moulding towards the front of the vehicle.
IV - FINAL OPERATION.
- Refit:
- the protective strip mounting bolt,
- the blanking cover,
- the mounted indicator.
Rear side door protective strip: Removal - Refitting
B85 or K85
REMOVAL
I - REMOVAL PREPARATION OPERATION

- Strip off the adhesive (1).
- Remove the bolt.
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Slide the door moulding towards the front of the vehicle.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Slide the door moulding towards rear of the vehicle.
II - FINAL OPERATION.
- Refit:
- the protective strip mounting bolt,
- the adhesives (Part no: 77 01 465 890).
C85 or S85
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip the rear wing protective strip (1).
REFITTING
I - REFITTING PREPARATION OPERATION
- Check the condition of the clips and replace them if
necessary.
II - REFITTING OPERATION FOR PART
CONCERNED
- Clip on the rear wing protective strip.
Roof protection strip: Removal - Refitting
C85 or S85
REMOVAL
Note:
It is possible to replace the access flap for
mounting the roof rack bars.
OPERATION FOR REMOVAL OF PART
CONCERNED

- Carefully unclip the roof protection strip.
REFITTING
I - REMOVAL PREPARATION OPERATION

- Check the condition of the clips (1) and replace if
necessary.
II - FINAL OPERATION.
- Clip the roof protection strip in position.
READ NEXT:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove the front wheel (see Wheel: Removal - R
B85 or C85 or S85, and EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2 or
EQUIPMENT LEVEL EA3 or
EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5, and DOCUMENTATION PHASE 1
STRIPPING
I - STRIPPING PREPARATION O
SEE MORE:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
WARNING
Prepare for brake fluid outflow, to prevent damage
to the mechanical parts and bodywork
around the braking system.
Fit the pedal press
Rev counter 1
(graduations x 1000)
Speedometer 2
(km or miles per hour)
Overspeed buzzer
Depending on the vehicle, a buzzer
sounds for approximately 10 seconds
every 40 seconds, as long as the vehicle
is travelling in excess of 72 mph
(120 km/h).
Driving style indicator 4
Please r
© 2016-2025 Copyright Renault Clio Owners Club
