Renault Clio: Cabin filter: Removal - Refitting

LEFT-HAND DRIVE

Note: The cabin filter is located in the passenger side A-pillar.

REMOVAL

I - REMOVAL PREPARATION OPERATION

SCHOOL VEHICLE

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Cabin filter: Removal - Refitting

Note: Foreign bodies (leaves, insects etc.) are likely to accumulate in the cabin filter. Remove the cabin filter with care so as to prevent foreign bodies getting into the evaporator.

REFITTING

I - REFITTING PREPARATION OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

III - FINAL OPERATION

SCHOOL VEHICLE

RIGHT-HAND DRIVE

REMOVAL

OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Cabin filter: Removal - Refitting

Note: Foreign bodies (leaves, insects etc.) are likely to accumulate in the passenger compartment filter.

Remove the filter with care so as to prevent foreign bodies getting into the evaporator.

REFITTING

I - REFITTING PREPARATION OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

Renault Clio. Cabin filter: Removal - Refitting

READ NEXT:

 Rear air distribution duct: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Lock the airbag computer using the Diagnostic tool (see Fault finding - Replacement of components) (MR 394, 88C, Airbags and pretensioners). Disconnect

 Recirculation control cable: Removal - Refitting

LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Partially remove seal (1). Remove the side panel (2). Remove the bolt (3) from the base

 Air distribution cable: Removal - Refitting

LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the glovebox (see Glovebox: Removal - Refitting) (MR 393, 57A, Interior equipment),

SEE MORE:

 Anti-lock braking system (ABS)

Under heavy braking, the ABS prevents the wheels from locking, allowing the stopping distance to be managed and keeping control of the vehicle. Under these circumstances, the vehicle can be steered to avoid an obstacle whilst braking. In addition, this system can increase stopping distances

 Camshaft dephaser: Removal - Refitting

M4R The engine and gearbox assembly must be removed to remove/refit the camshaft dephaser (see 10A, Engine and cylinder block assembly, Engine - gearbox assembly: Removal - Refitting, 10A-112). For the camshaft dephaser removal-refitting procedure (see ) (Technical Note 6020A, 10A, Engine and

© 2016-2025 Copyright Renault Clio Owners Club