Renault Clio: Sender: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Tank / Sender: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02, Lifting equipment).
- Drain the fuel tank (see 19C, Tank, Fuel tank: Draining, 19C-8).
- Remove the battery covers.
- Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).
- Remove the fuel tank (see 19C, Tank, Fuel tank: Removal - Refitting, 19C-1).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Remove the mounting nut from the sender unit using (Mot. 1397)
- Let the fuel drain from the sender.
- Remove the sender unit, being careful with the float.
WARNING
Refit the sender nut as soon as the sender has been removed to prevent any deformation of the fuel tank.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Replace the O-ring.
- Refit the pump - sender by positioning the mark (1) on the sender opposite the mark (2) on the tank.
- Position the sender mounting nut.
- Tighten the sender mounting nut using the (Mot.1397) until the mark on the nut (3) lines up with the mark (2) on the tank and the mark (1) on the sender.
II - FINAL OPERATION.
- Refit the fuel tank (see 19C, Tank, Fuel tank: Removal - Refitting, 19C-1).
- Connect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).
READ NEXT:
Pump - sender: Removal - Refitting
K9K, and 772
IMPORTANT
During this operation, be sure to:
beware of fuel splashes when disconnecting the
union,
protect sensitive areas from fuel outflow.
IMPORTANT
Wear gloves during this opera
Pump - sender - filter: Removal - Refitting
D4F or F4R or K4J or K4M or M4R
IMPORTANT
During this operation, be sure to:
be careful of fuel splashes when disconnecting the
union.
IMPORTANT
Wear goggles with side protectors for this operati
SEE MORE:
Tyre pressure: Identification
I - INFLATION
WARNING
If checking the tyre pressure when hot, increase the
recommended pressure by 0.2 to 0.3 bar.
B85 or C85 or S85
The pressure values given are recommendations when
cold.
K85
II - CONFORMITY CHECK AND ADJUSTMENT
If the tyre size is changed, calibrate the electric power-assisted
Scuttle side panel: General description
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general information,
make sure that there are no special notes associated
with the vehicle. These special notes are specified
i
© 2016-2025 Copyright Renault Clio Owners Club
