Renault Clio: C-pillar upper trim: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Trim And Upholstery / Body Internal Trim / C-pillar upper trim: Removal - Refitting
C85
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the rear wing panel lining (see 71A, Body internal trim, Rear panel lining: Removal - Refitting, 71A-32),
- the rear roof drip moulding lining (see 71A, Body internal trim, Side roof rail rear trim: Removal - Refitting, 71A-17),
- the rear quarter panel lining (see 71A, Body internal trim, Quarter panel trim: Removal - Refitting, 71A-27).
II - REFITTING OPERATION FOR PART CONCERNED
- Remove clips (1) using a pair of unclipping pliers.
- Remove the C-pillar upper trim.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit:
- the C-pillar upper trim,
- clips (2).
II - FINAL OPERATION
- Remove:
- the rear wing panel lining (see 71A, Body internal trim, Rear panel lining: Removal - Refitting, 71A-32),
- the rear quarter panel lining (see 71A, Body internal trim, Quarter panel trim: Removal - Refitting, 71A-27),
- the rear roof drip moulding lining (see 71A, Body internal trim, Side roof rail rear trim: Removal - Refitting, 71A-17).
READ NEXT:
Quarter panel trim: Removal - Refitting
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see Airbag and pretensioners: Precautions
for the repair) (88C, Airbags and pretensio
Rear panel lining: Removal - Refitting
C85 or S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the complete rear bench seat.
Remove:
the front seat belt support bolt (1).
the front seat belt support.
Unclip:
the re
Rear parcel shelf side trim: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
C85
Remove the rear wing panel trim (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32).
B85
Unclip the rear inner sill upper
SEE MORE:
Clutch circuit: Removal - Refitting
JH3 or JR5
Note:
Each time an operation is carried out on the
hydraulic clutch system, bleed the circuit:
between the reservoir and the bleed hole,
between the bleed hole and the clutch release
bearing.
REMOVAL
I - REMOVAL PREPARATION OPERATION
K4J or K4M
Remove the resonator.
Remov
Display A
To access display 1 for setting the time,
press button 2 or 3. Wait for a few seconds.
The hours and minutes flash and you
are now in setting mode; press and
hold button 2 or 3 to set the hours.
Once the minutes flash, repeatedly
press or press and hold button 2 ou 3
to set the time.
© 2016-2025 Copyright Renault Clio Owners Club
