Renault Clio: Hill start assistance
Renault Clio IV (2014-2019) Owners Manual / Driving / Driver correction devices and aids / Hill start assistance
This function assists the driver when starting on hills. It prevents the vehicle from rolling backwards, depending on the slope, by automatically applying the brakes when the driver lifts his/her foot off the brake pedal to depress the accelerator pedal.
System operation
It only operates when the gear lever is in a position other than neutral (other than N or P for automatic transmissions) and the vehicle is completely stationary (brake pedal depressed) The system holds the vehicle for approximately 2 seconds. The brakes are then gradually released (the vehicle will move according to the slope).
| The hill start assistance
system cannot completely
prevent the vehicle from
rolling backwards in all situations
(extremely steep gradients,
etc.). In all cases, the driver may depress the brake pedal to prevent the vehicle from rolling forwards or backwards. The hill start assistance function should not be used for prolonged stops: use the brake pedal. This function is not designed to immobilise the vehicle permanently. If necessary, use the brake pedal to stop the vehicle. The driver must remain particularly vigilant when driving on slippery or low-grip surfaces and/or on hills. Risk of serious injury |
READ NEXT:
Speed limiter
The speed limiter function helps you
stay within the driving speed limit that
you choose, known as the limit speed.
Controls
Main “On/Off” switch.
Limit speed activation, storage
Cruise control
The cruise control function helps you to
maintain your driving speed at a speed
that you choose, called the cruising
speed.
This cruising speed may be set at any
speed above 20 mph (30 km/h
Parking sensor
Operating principle
Ultrasonic detectors, installed in the
rear bumper (depending on the vehicle),
measure the distance between the
vehicle and an obstacle whilst reversing.
This measurement is
SEE MORE:
Front left-hand wiring: Connector access
I - LOCATION OF CONNECTORS
Connection R 107 (front left-hand wiring/dashboard
wiring connection) composed of two to four connectors
depending on equipment.
R 374 connector (front left-hand wiring/rear left-hand
wiring connection).
Connection R 67 (front left-hand wiring/engine wiring
Structural bodywork documentation: Use
B85 or C85
I - CLASSIFYING INFORMATION
This information is classified in two complementary
documents:
1 - Vehicle structure bodywork repair procedures
(MR of the vehicle concerned)
This document comprises two sections:
a - Section 0:
This section does not contain repair methods, it only
contains des
