Renault Clio: Rear end panel lining: Removal - Refitting

REMOVAL
I - REMOVAL PREPARATION OPERATION
B85 or C85 or S85

- Remove the luggage compartment carpet.
K85

- Remove the luggage compartment raised floor (1).

- Remove the luggage compartment carpet (2).
- Partially remove the luggage compartment seal.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
B85 or C85 or S85

- Remove the clips (3) using a flat-blade screwdriver.

- Remove the towing ring bolts (4).

- Unclip the rear end panel trim.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Refit:
- the rear end panel lining,
- the towing rings.
- Torque tighten the towing ring bolts (21 Nm).
B85 or C85 or S85

II - FINAL OPERATION.
B85 or C85 or S85
- Refit the luggage compartment carpet.
K85
- Remove:
- the luggage compartment carpet (2),
- the luggage compartment raised floor (1).
- Refit the luggage compartment seal.
READ NEXT:
S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the rear parcel shelf,
the centre rear parcel shelf (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the clips (2).
Remove
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the front speaker (see Front speakers:
Removal - Refitting) (MR 392, 86A, Radio).
Unclip the door mirror trim piece (1).
II - OPERATION FOR REM
SEE MORE:
This system enables a reduced fuel
consumption and lower greenhouse
gas emissions. The system is activated
automatically when the vehicle is
started. While driving, the system stops
the engine (standby) when the vehicle
is at a standstill (traffic jam, traffic lights,
etc).
Conditions for en
K9K
I - RISKS RELATING TO CONTAMINATION
The high-pressure direct injection system is highly sensitive
to contamination. The risks caused by contamination
are:
damage to or destruction of the high pressure injection
system,
a component seizing,
a component not being properly sealed.
All After-S
© 2016-2025 Copyright Renault Clio Owners Club
