Renault Clio: 3rd brake light: Removal - Refitting
B85 or C85 or S85
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the blanking covers (1).

- Insert a screwdriver in the openings to move the clips (2).

- Apply pressure to the clips (2) to unclip the high level
brake light.
- Partially remove the raised brake light using a flat-blade
screwdriver while protecting the tailgate area
with masking tape.
- Disconnect the connector (3).
- Unclip the window washer jet by moving the clips (4).
- If replacing the high level brake light, remove the
bulb (see 81A, Rear lighting, High level brake
light bulb: Removal - Refitting, 81A-12).
REFITTING
REFITTING OPERATION FOR PART CONCERNED
- If replacing the high level brake light, refit the bulb
(see 81A, Rear lighting, High level brake light
bulb: Removal - Refitting, 81A-12).
- Connect the connector.
- Clip:
- the window washer jet,
- the high level brake light.
- Refit the blanking covers.
K85
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the tailgate spoiler (see Tailgate spoiler:
Removal - Refitting) (56A, Exterior equipment).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove:
- the bolts (1) of the high-level brake light on the tailgate,
- The high-level brake light.
- If replacing the high-level brake light, remove the
bulb (see 81A, Rear lighting, High level brake
light bulb: Removal - Refitting, 81A-12).
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- If replacing the high-level brake light, refit the bulb
(see 81A, Rear lighting, High level brake light
bulb: Removal - Refitting, 81A-12).
- Refit the high-level brake light on the tailgate.
II - FINAL OPERATION.
- Refit the tailgate spoiler (see Tailgate spoiler: Removal
- Refitting) (56A, Exterior equipment).
READ NEXT:
K85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the tailgate spoiler (see Tailgate spoiler: Removal - Refitting),
the high level brake light (see 81A, Rear lighting,
3rd brake light: Rem
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
K85, and DOCUMENTATION PHASE 1
Move the rear fog light using the tool (Car. 1363) as a lever at (1).
B85 or C85 or S85, and DOCUMENTATION
PHASE 2
Interior lighting: Function
I - GENERAL INFORMATION
Vehicles may be fitted with the following units for lighting
the interior of the passenger compartment, depending
on the level of equipment:
a cou
SEE MORE:
DP0
Do not drain or remove the automatic gearbox in order
to remove the speed sensor.
The output speed sensor has been deleted and replaced
with wheel speed sensors.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A,
Tyre and wheel safety
The tyres are the only contact between
the vehicle and the road, so it is essential
to keep them in good condition. You
must comply with the local rules given
in the highway code.
For your safety, please respect
the speed limit.
When they need to be replaced,
© 2016-2025 Copyright Renault Clio Owners Club
