Renault Clio: Automatic gearbox: Identification
Renault Clio III (2005-2013) Service Manual / Transmission / Automatic Gearbox / Automatic gearbox: Identification
DP0
The automatic transmission series number can be found in two places: on a label on the hydraulic distributor cover (1) and etched onto the outer casing (2) on the wheel side.
Automatic gearbox oil: Draining - Filling
DP0
I - OIL SERVICE
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment).
Note:
Drain the automatic transmission oil when the oil
is warm (60READ NEXT:
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the engine undertray,
the fr
Automatic gearbox: Removal - Refitting
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the gearbox (see 23A, Automatic gearbox,
Automatic gearbox: Removal - Refitting, 23A-7).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Drive plate: Removal - Refitting
DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Shift the selector lever to Neutral.
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove
the battery tray (se
Multifunction switch: Removal - Refitting
SEE MORE:
DP0
Do not drain or remove the automatic gearbox in order
to remove the speed sensor.
The output speed sensor has been deleted and replaced
with wheel speed sensors.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A,
Speed sensor: Removal - Refitting
D4F or F4R or K4J or K4M
Operating diagram of the petrol supply circuit ( " pump - sender - fuel
filter " assembly).
The fuel system does not have a return.
The fuel pressure does not vary with engine load.
The circuit comprises:
a rail (1) without a return pipe union and without a
supply pre
Fuel circuit: Operating diagram
