Renault Clio: Rear air distribution duct: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Air Conditioning / Heating / Rear air distribution duct: Removal - Refitting

Renault Clio. Rear air distribution duct: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

Renault Clio. Rear air distribution duct: Removal - Refitting

1 - Rear left-hand air distribution duct

2 - Rear right-hand air distribution duct

II - OPERATION FOR REMOVAL OF PART CONCERNED

1 - Rear left-hand air distribution duct

Renault Clio. Rear air distribution duct: Removal - Refitting

2 - Rear right-hand air distribution duct

Renault Clio. Rear air distribution duct: Removal - Refitting

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

1 - Rear left-hand air distribution duct

Renault Clio. Rear air distribution duct: Removal - Refitting

2 - Rear right-hand air distribution duct

Renault Clio. Rear air distribution duct: Removal - Refitting

II - FINAL OPERATION.

1 - Rear left-hand air distribution duct

2 - Rear right-hand air distribution duct

READ NEXT:

 Recirculation control cable: Removal - Refitting

LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Partially remove seal (1). Remove the side panel (2). Remove the bolt (3) from the base

 Air distribution cable: Removal - Refitting

LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the glovebox (see Glovebox: Removal - Refitting) (MR 393, 57A, Interior equipment),

 Air mixing cable: Removal - Refitting

LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Partially remove seal (1). Remove the side panel (2). Remove the bolt (3) from the base

SEE MORE:

 Air filter unit: Removal - Refitting

D4F, and 740 or 742 or 764 REMOVAL I - REMOVAL PREPARATION OPERATION Apply pressure to (1). Pull at (2). Remove the air breather sleeve (3) from the front end panel. Undo the clip (4) mounting the air filter unit to the motorised throttle valve. Disconnect the oil vapour rebreathing hose

 Solenoid valves: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Note: Before removing the solenoid valves, always mark their respective connectors in order not to mix them up. IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the acc

© 2016-2025 Copyright Renault Clio Owners Club