Renault Clio: Rear fog lights: Removal - Refitting

REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
K85, and DOCUMENTATION PHASE 1

- Move the rear fog light using the tool (Car. 1363) as a lever at (1).
B85 or C85 or S85, and DOCUMENTATION
PHASE 2

- Move the rear fog light using the tool (Car. 1363) as a lever at (2).
- Disconnect the rear fog light connector.
- Remove the rear fog light.
REFITTING
I - REFITTING PREPARATION OPERATION
K85, and DOCUMENTATION PHASE 1

- If the indicator light bulb needs replacing, remove:
- the bulb holder (3) by turning it forty-five degrees
counter-clockwise,
- the bulb from the bulb holder.
B85 or C85 or S85, and DOCUMENTATION
PHASE 2

- If the indicator light bulb needs replacing, remove:
- the bulb holder (4) by turning it forty-five degrees
counter-clockwise,
- the bulb from the bulb holder.
- When replacing a bulb, use an approved bulb.
II - REFITTING OPERATION FOR PART
CONCERNED
- Refit:
- the bulb on the bulb holder,
- the bulb holder by turning it forty-five degrees
clockwise.
- Connect the rear fog light connector.
- Clip the fog light onto the rear bumper.
Number plate light: Removal - Refitting
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the licence plate light using a flat-blade
screwdriver.
- Disconnect the connector.

- Unclip the light at (1) to gain access to the bulb.
REFITTING
REFITTING OPERATION FOR PART CONCERNED
- When replacing a bulb, use an approved bulb.

- Connect the connector.
- Refit the light.
READ NEXT:
Interior lighting: Function
I - GENERAL INFORMATION
Vehicles may be fitted with the following units for lighting
the interior of the passenger compartment, depending
on the level of equipment:
a cou
Fuses: List and location of components
Passenger compartment fuse and
relay box
Consumer cut-out fuse
Additional relay/fuse box
Battery protection fuses
Protection and switching unit
Power sup
SEE MORE:
I - SPECIAL NOTES
Its role is to modify the valve timing.
To improve cylinder filling at all engine speeds, the engine is fitted with an
inlet camshaft dephaser (1).
Dephasing at the moment when the inlet valves close
optimises filling according to engine speed. Torque at
midrange engine speed an
PANORAMIC SUNROOF
IMPORTANT
Before working on or near a safety system component;
make sure that the airbag computer is
locked using the Diagnostic tool. When this
function is activated, all the triggering lines are
inhibited and the airbag warning light on the
instrument panel is continuously lit (
© 2016-2025 Copyright Renault Clio Owners Club
