Renault Clio: Right-hand drive

The equipment fitted, described below, DEPENDS ON THE VERSION AND COUNTRY.
- Side air vent.
- Passenger Airbag location.
- Heating or air conditioning controls.
- Multimedia touch-screen.
- Windscreen demister outlet.
- Hazard warning lights switch.
- Door electric locking switch.
- Centre air vents.
- Stalk:
- direction indicator lights;
- exterior lights;
- front fog lights;
- rear fog lights.
- Instrument panel.
- Driver Airbag and horn location.
- Multimedia system voice control
button.
- Stalk:
- windscreen and rear screen
wash/wipe;
- trip computer and warning
system information readout.
- Side air vent.
- Controls for:
- electric headlight beam adjustment,
- instrument panel lighting dimmer,
- activate/deactivate the parking
distance control system,
- activation/deactivation of the Stop
and Start function.
- Cruise control/speed limiter controls.
- Control for adjusting steering
wheel height and reach.
- Cruise control/speed limiter main
control.
- Activation/deactivation control for
ECO mode.
- Handbrake.
- Gear lever.
- Cigarette lighter/accessories
socket.
- RENAULT card reader.
- Engine start/stop button.
- Storage space.
- Glovebox.
- Bonnet release control.
READ NEXT:
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT
AND COUNTRY.
Instrument panel A: lights up when
the ignition is switched on. The brightness
can be adjusted by turning
Rev counter 1
(graduations x 1000)
Speedometer 2
(km or miles per hour)
Overspeed buzzer
Depending on the vehicle, a buzzer
sounds for approximately 10 seconds
every 40 seconds, as long
On-board computer 1
Depending on the vehicle, this includes
the following functions:
distance travelled;
journey settings;
information messages;
operating fault messages (connected
t
SEE MORE:
Depending on the vehicle, they will consist
of:
front seat belt inertia reel pretensioners;
chest-level load limiters;
air bags for driver and front passenger.
These systems are designed to act independently
or together when the vehicle
is subjected to a frontal impact.
Depending on
Remove the wheel trim using hubcap
tool 1 (located in the tool kit) by engaging
the hook in the opening near
valve 2.
To refit it, align it with valve 2. Push the
retaining hooks in fully, starting with
side A near the valve, followed by B
and C, finishing at D opposite the valve.
© 2016-2025 Copyright Renault Clio Owners Club
