Renault Clio: Wheel speed sensor: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Chassis / Anti-lock Braking System / Wheel speed sensor: Removal - Refitting

EQUIPMENT LEVEL EAC or EQUIPMENT LEVEL SPORT

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Position the vehicle on a two-post lift (see 02A, Lifting Equipment, Vehicle: Towing and lifting).
• Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting).
• Remove:
  • the front wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1),
  • the wheel arch liners (see MR 393 Bodywork, 55A, Exterior protection, Front wheel arch liner: Removal - Refitting).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Detach the wheel speed sensor wiring harness.
• Disconnect the wheel speed sensor in the wheel arch.

• Remove:
  • the mounting bolt (1) from the wheel speed sensor,
  • the wheel speed sensor.

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

• Refit:
  • the wheel speed sensor,
  • the mounting bolt to the wheel speed sensor.
• Torque tighten the wheel speed sensor mounting bolt (8 Nm).
• Connect the wheel speed sensor in the wheel arch.

II - FINAL OPERATION.

• Refit:
  • the wheel arch liners (see MR 393 Bodywork, 55A, Exterior protection, Front wheel arch liner: Removal - Refitting),
  • the front wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
• Connect the battery (see 80A, Battery, Battery: Removal - Refitting).

READ NEXT: