Renault Clio: Cruise Control
Cruise control - speed limiter: List and location of components
CRUISE CONTROL
I - LIST OF COMPONENTS
- Switch
- Steering wheel switch
- Brake switch
- Clutch switch
II - LOCATION OF COMPONENTS
1 - Switch

2 - Steering wheel switch

3 - Brake switch

4 - Clutch switch

Switch: Removal - Refitting
CRUISE CONTROL

REMOVAL
I - REMOVAL PREPARATION OPERATION

- Unclip the switch panel (1) using the (Car. 1363).
- Disconnect the connectors.
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the switch by pressing on the clips (2).
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Refit the switch on the switch panel.
- Connect the connectors.
II - FINAL OPERATION.
- Clip the switch panel onto the lower cover.
READ NEXT:
Rotary switch: Removal - Refitting
The rotary switch is part of the steering column control
assembly. It cannot be replaced on its own.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the steering
Wiping and washing: List and location of components
Passenger compartment
fuse and relay box
Protection and Switching
Unit
Power supply fuse board
UCH
Rain sensor
Wiper switch
Windscreen wip
Radio: List and location of components
I - LIST OF COMPONENTS
The radio system comprises:
a radio control satellite (see 86A, Radio, Radio control
satellite: Removal - Refitting, 86A-19)
a radio a
SEE MORE:
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Put the vehicle on a two-post lift (see Vehicle: Towing and lifting).
Disconnect the battery (see Battery: Removal - Refitting).
Remove the engine undertray.
Unclip the connector cover (1).
Remove the oil pressure sensor
Rear axle assembly: Adjustment values
EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2
or EQUIPMENT
LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG
I - PRELIMINARY OPERATIONS
Before checking the axles on the test bench, check the
tyre press
© 2016-2025 Copyright Renault Clio Owners Club
