Renault Clio: Rear inner sill upper trim: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Trim And Upholstery / Body Internal Trim / Rear inner sill upper trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the complete rear bench seat.
- Partially remove seal (1).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Remove the trim at (2) and at (3).
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit the rear door sill upper trim.
II - FINAL OPERATION
- Refit the seal (4).
- Refit the rear bench seat.
READ NEXT:
C-pillar upper trim: Removal - Refitting
C85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the rear wing panel lining (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32),
the rear roof drip moulding lini
Quarter panel trim: Removal - Refitting
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see Airbag and pretensioners: Precautions
for the repair) (88C, Airbags and pretensio
Rear panel lining: Removal - Refitting
C85 or S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the complete rear bench seat.
Remove:
the front seat belt support bolt (1).
the front seat belt support.
Unclip:
the re
SEE MORE:
Additional methods of restraint
All of the warnings below are given so that the airbag is not obstructed in
any way when it is inflated and also to prevent
the risk of serious injuries caused by items which may be dislodged when it
inflates.
The airbag is designed to complement the action of the seat belt.
Both th
Oil vapour rebreathing circuit: Descriptions
K4J or K4M, and 780 or 800 or 801
Oil vapour rebreathing duct
Calibrated port
Oil vapour recovery plate
located on the rocker cover
Oil vapour rebreathing hole
Oil vapour rebreathing circuit: Operating diagram
K4J, and 780 - K4M, and 800 or 801
A: under low loads, the oil vapours are rebr
© 2016-2025 Copyright Renault Clio Owners Club
