Renault Clio: Scoop under the scuttle panel grille: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Mechanisms And Accessories / Exterior Equipment / Scoop under the scuttle panel grille: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the scuttle panel grille (see 56A, Exterior equipment, Scuttle panel grille: Removal - Refitting, 56A-1).
- Remove the trim under the scuttle panel grille (1).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Remove:
- the bolts (2),
- the blanking covers (3).
- Remove the bolts (4).
- Extract the scoop under the scuttle panel grille.
REFITTING
I - REFITTING PREPARATION OPERATION
WARNING
It is essential to replace the foam strips which seal the scoop under the scuttle panel grille. The foam strips are available from the Parts Department.
II - REFITTING OPERATION FOR PART CONCERNED
- Refit the bolts (5).
- Refit:
- the blanking covers (6),
- the bolts (7).
III - FINAL OPERATION
- Reclip the trim under the scuttle panel grille.
- Refit the scuttle panel grille (see 56A, Exterior equipment, Scuttle panel grille: Removal - Refitting, 56A-1).
READ NEXT:
Door mirror: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Unclip the trim (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove:
the sealing foam (2),
the bolts (3)
the door mirror.
Disconnect th
Side decorative strips: Removal - Refitting
Note:
Once removed, the side decorative strips cannot
be refitted and must be replaced each time.
REMOVAL
I - REMOVAL PREPARATION OPERATION
1 - Front side door
Remove:
the front side door trim (se
Sill panel extension: Removal - Refitting
EQUIPMENT LEVEL EAC or EQUIPMENT LEVEL SPORT
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the bolts (1).
Detach the decorative strip (2).
Note:
Replace the decorative strip (2) ever
SEE MORE:
Front side member: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general informati
Flow actuator: Removal - Refitting
K9K, and 750 or 752 or 766 or 768
IMPORTANT
Before carrying out any work on the injection system,
check using the Diagnostic tool :
that the injector rail is not under pressure,
that the fuel temperature is not too high.
It is essential to respect the safety and cleanliness
advice whenever work
© 2016-2025 Copyright Renault Clio Owners Club
