Renault Clio: Rear end panel lining: Removal - Refitting

REMOVAL
I - REMOVAL PREPARATION OPERATION
B85 or C85 or S85

- Remove the luggage compartment carpet.
K85

- Remove the luggage compartment raised floor (1).

- Remove the luggage compartment carpet (2).
- Partially remove the luggage compartment seal.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
B85 or C85 or S85

- Remove the clips (3) using a flat-blade screwdriver.

- Remove the towing ring bolts (4).

- Unclip the rear end panel trim.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Refit:
- the rear end panel lining,
- the towing rings.
- Torque tighten the towing ring bolts (21 Nm).
B85 or C85 or S85

II - FINAL OPERATION.
B85 or C85 or S85
- Refit the luggage compartment carpet.
K85
- Remove:
- the luggage compartment carpet (2),
- the luggage compartment raised floor (1).
- Refit the luggage compartment seal.
READ NEXT:
S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the rear parcel shelf,
the centre rear parcel shelf (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the clips (2).
Remove
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the front speaker (see Front speakers:
Removal - Refitting) (MR 392, 86A, Radio).
Unclip the door mirror trim piece (1).
II - OPERATION FOR REM
SEE MORE:
K9K, and 764 or 772
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the air filter box inlet air pipe (1).
Remove the turbocharger outlet air pipe retaining pins (2).
Remove:
the turbocharger outlet air pipe bolt (3),
the turbocharger outlet air pipe
Undo the clip (4) from the int
D4F, and 740
WARNING
Do not use any product designed to improve electrical
contact in the injection computer connectors
and oxygen sensors and on the oxygen sensor
body. Failure to respect this advice prevents the
oxygen sensor from operating correctly and results
in failure to comply with the emis
© 2016-2025 Copyright Renault Clio Owners Club
